LAN connector
(see figure 4 on the previous page) — Connect a control or controlled
B
device to the receiver for 10/100Base-T Ethernet communication through this
pass-through connector. LEDs on the connector indicate link and activity status.
RS-232 Over XTP connector
C
between XTP-compatible devices, connect a control device to the 5-pole captive screw
connector. The connector includes only the two poles labeled "RS-232" and shares the
ground pole with the IR poles.
IR Over XTP connector
a control device to the 5-pole captive screw connector. This connector includes only the
two poles labeled "IR" and shares the ground pole with the RS-232 poles.
NOTE: RS-232 and IR data can be transmitted or received simultaneously (see
RS-232 and IR Over XTP Communication
Receiver output connections
HDMI output connector and audio switch
D
HDMI connector. To mute or unmute the embedded audio, hold the HDMI audio switch
up or down (see
HDMI Audio Switch
DVI (with an appropriate adapter) signals.
NOTES:
•
The maximum cable length for HDMI cables is 15 feet (4.6 meters).
•
Use an Extron LockIt Lacing Bracket to secure the HDMI connector to the
device (see
HDMI Connection
Analog audio output connector
E
mono audio output device to the 3.5 mm, 5-pole captive screw connector (see figure 5
for wiring details).
Tip
Ring
Sleeves
Tip
Ring
Balanced Audio Output
Figure 5.
Audio Output Wiring
ATTENTION:
•
For unbalanced audio, connect the sleeves to the contact ground. Do not
connect the sleeves to the negative (-) contacts.
•
Pour l'audio asymétrique, connectez les manchons au contact au sol. Ne pas
connecter les manchons aux contacts négatifs (–).
NOTE: If the device is receiving 2-channel LPCM embedded audio on the HDMI
input signal, the audio signal is extracted and converted to a stereo analog signal.
S/PDIF output connector
F
connector for digital S/PDIF audio output. The type of audio present on this output is
dictated by the following (see
formats on the S/PDIF output):
The audio format selected on the source material or device.
•
The source device automatically outputting an audio format through EDID.
•
XTP T HD 4K Transmitter and XTP R HD 4K Receiver • Installation
— To pass bidirectional serial or other control signals
— To transmit and receive IR signals (up to 56 kHz), connect
on page 12 for wiring details).
— Connect a display device to the female
on page 17). The connector supports HDMI or
on the next page).
— Connect a balanced or unbalanced, stereo or
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Audio Output
— Connect an audio device to the female orange RCA
Audio Output Overview
Do not tin the wires!
on page 18 for supported audio
8