Table of Contents
Advertisement
Audio panel
Audio format
(see figure 26 on the previous page) — Select one of the following radio
4
buttons to determine the audio input format:
Auto Detect — Automatically detects the input audio format. When enabled, HDMI
•
audio has priority over analog audio.
HDMI — Transmits embedded audio from an HDMI signal.
•
Analog — Transmits an analog audio signal.
•
Analog audio
— If applicable, move the handle of the
5
or down or specify the desired gain in the field below the slider to adjust the audio gain
or attenuation in dB.
Audio output
— Select the
6
for audio-only transmission to the HDMI output connector on a connected receiver. By
default, the check box is not selected.
If selected, also select the black signal resolution from the
menu. The default resolution is 720p @ 60 Hz.
Factory reset
Factory Reset
— Click the
7
settings except for firmware (see mode 5 in
NOTE: This is the same as the
command on page 25).
Device Information panel
The
Device Information panel
side of the software screen displays device
information and settings.
Model — Displays the device model.
1
Firmware Version — Displays the firmware
2
and build version.
Signal Present — Indicates whether an active
3
signal is on the input.
HDCP — Displays the HDCP status of an
4
active input.
EDID — Displays the current resolution and
5
refresh rate.
Selected Audio Input — Displays the audio
6
format of the selected input.
Audio only — Displays whether only audio is
7
sent to outputs.
Analog Audio Gain — Displays the gain for
8
analog audio.
XTP T HD 4K Transmitter and XTP R HD 4K Receiver • XTP System Configuration Software
Analog Audio Gain
check box to enable a black signal
Enable Audio Only
button to reset the transmitter to factory
Factory Reset
Reset Modes
E
SIS command (see the
ZXXX
on the right
slider up
drop-down
Signal Type
on page 19).
Reset mode
SIS
36
Advertisement
Table of Contents
