Table of Contents
Advertisement
Analog audio input connector
C
audio source to the 5-pole captive screw connector (see figure 3 for wiring details).
Tip
Ring
Sleeves
Tip
Ring
Balanced Audio Input
Figure 3.
Audio Input Wiring
Transmitter XTP interconnection
RS-232 Over XTP connector
D
XTP-compatible devices, connect a control device to the 5-pole captive screw
connector. The connector includes only the two poles labeled "RS-232" and shares the
ground pole with the IR poles.
IR Over XTP connector
a control device to the 5-pole captive screw connector. The connector includes the
two poles labeled "IR" and shares the ground pole with the RS-232 poles.
NOTE: RS-232 and IR data can be transmitted or received simultaneously (see
RS-232 and IR Over XTP Communication
XTP output connector
E
(see
Twisted Pair Cable Termination and Recommendations for XTP
Communication
on page 10) to the RJ-45 XTP output connector. The cable carries
the following signals:
•
Digital video
Digital audio
•
•
Bidirectional RS-232 and IR commands
Signal LED indicator — Lights green when the transmitter outputs an XTP
signal to a compatible receiver or matrix switcher.
Link LED indicator — Lights yellow when XTP devices are connected and
communication is established.
ATTENTION:
•
Do not connect this connector to a computer data or telecommunications
network.
•
Ne connectez pas cet connecteur à un réseau de télécommunications ou de
données informatiques.
•
XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see
page 15).
•
XTP à distance est destiné à une utilisation en intérieur seulement. Aucune
partie du réseau qui utilise l'alimentation XTP à distance ne peut être routée en
extérieur (voir
Remote power
LAN connector
— Connect a control or controlled device to the pass-through LAN
F
connector for 10/100Base-T Ethernet communication. LEDs on the connector indicate
link and activity status.
XTP T HD 4K Transmitter and XTP R HD 4K Receiver • Installation
(see figure 2 on the previous page) — Connect an
Tip
Sleeve
Tip
Sleeve
Unbalanced Audio Input
— To pass bidirectional serial signals between
— To transmit and receive IR signals (up to 56 kHz), connect
on page 12 for wiring details).
— Connect an XTP twisted pair receiver or matrix switcher
•
Remote power
Ethernet communication
•
•
System communication
à la page 15).
Do not tin the wires!
Signal
Link
Remote power
on
6
Advertisement
Table of Contents
