Extron electronics XTP T HD 4K User Manual page 33

Command
Device Commands
Device name
Set device name
Reset device name
View device name
Reset mode
Reset user settings to factory
defaults
Status
View input signal presence
View input HDCP status
View output HDCP status
View firmware version
View firmware version and
build
View part number
NOTES:
X1@
= Device name
X1#
= Video signal status
X1$
= Input HDCP status
X1%
= Output HDCP status
XTP T HD 4K Transmitter and XTP R HD 4K Receiver • SIS Configuration and Control
ASCII Command ASCII Response
(Host to Device) (Device to Host)
E X1@ }
CN Ipn
E • }
CN Ipn
E }
CN Ipn
E }
ZXXX Zpx
0LS
Frq
E }
IHDCP HdcpI
E }
OHDCP HdcpO
Q
X.XX
*Q
X.XX.XXXX
N
60-1524-12
Text label, maximum 16 alphanumeric characters
= video or TMDS signal not detected
0
= video or TMDS signal detected
1
= no source detected
0
= HDCP-compliant source detected
1
= non-compliant source detected
2
, , , = no sink device detected
0 2 4 6
, , = sink device detected but the output signal is not encrypted
1 3 5
= sink device detected and the output signal is encrypted
7
Additional Description
• X1@]
Set the device name to
] Reset the device name to the
•
XTP_Tx
factory default name.
View the current device name.
• X1@]
] Reset all user settings back to
factory default values. Firmware
is not reset.
X1#] View the video or TMDS signal
status of the input.
X1$] View the HDCP status of the
input.
View the HDCP status of the
X1%]
output.
View the current firmware
]
version.
View the current firmware
]
version and build number.
View the transmitter part
]
number.
X1@
.
25