Table of Contents
Advertisement
Receiver relay connection
G
Receiver power connection
H
Connection Details
HDMI Connection
To secure the HDMI cable to the HDMI connector, use an Extron LockIt Cable Lacing
Bracket and a tie wrap.
1
Figure 6.
1.
2.
3.
4.
5.
Relay connector
(see figure 4 on page 7) — Connect equipment controlled through
momentary or latching contact, like projector screens or lifts, to the normally open
relays.
ATTENTION:
•
Do not exceed 24 V at 1.0 A for each port.
•
Ne pas dépasser 24 volts à 1,0 A pour chaque port.
Power connector and LED
captive screw connector. For wiring considerations, see
page 13. The Power LED lights to indicate the device is receiving power. It is the same
as the front panel Power LED (see
NOTE: The XTP R HD 4K can also be powered remotely (see
page 15).
3
2
Installing the LockIt Lacing Bracket
Plug the HDMI cable into the panel connection (see figure 6,
Loosen the HDMI connection mounting screw from the panel (
LockIt over it. The screw does not have to be removed.
Place the LockIt on the screw and against the HDMI connector (
the screw to secure the bracket.
Loosely place the included tie wrap around the HDMI connector and the LockIt (
While holding the connector securely against the cable lacing bracket, use pliers or
similar tools to tighten the tie wrap. Remove any excess length (
ATTENTION:
•
Connect and pull the tie wraps until they are secure. Do not overtighten.
•
Connectez et tirez les serre-câbles jusqu'à ce qu'ils soient sécurisés. Ne pas
trop serrer.
XTP T HD 4K Transmitter and XTP R HD 4K Receiver • Installation
— Connect the 12 V, 1.5 A power supply to the 2-pole
figure
13,
on page 17).
A
4
3
5
Power Connection
on
Remote power
on
).
1
) enough to place the
2
), and then tighten
3
).
4
).
5
9
Advertisement
Table of Contents
