Remote Power - Extron electronics XTP T HD 4K User Manual

Remote power

The XTP T HD 4K and XTP R HD 4K can be powered remotely through an XTP Power
Injector or through an XTP matrix switcher.
ATTENTION:
• XTP remote power is intended for indoor use only. No part of the network that uses
XTP remote power should be routed outdoors.
• XTP à distance est destiné à une utilisation en intérieur seulement. Aucune partie
du réseau qui utilise l'alimentation XTP à distance ne peut être routée en extérieur.
Power injector
To power the XTP T HD 4K or XTP R HD 4K remotely with an XTP Power Injector, power
one device locally (see Local power
XTP cable run along the XTP connectors (see the XTP Power Injector User Guide at
www.extron.com for more installation information).
INPUTS
POWER
AUDIO
12V
0.7A MAX
XTP T HD 4K
HDMI LOOP THRU
Extron
XTP T HD 4K
XTP Transmitter
12V Local Power
Supply
Figure 11. Typical Pont-to-Point Application with Remote Power to an
XTP R HD 4K
NOTE: The power injector provides remote power up to 330 feet with a shielded twisted
pair cable with 24 AWG wire.
XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power to
connected XTP devices (see the XTP matrix switcher user guide at
more details). To manage available power from the XTP matrix switcher, use the XTP System
Configuration Software with the XTP matrix switcher.
XTP T HD 4K Transmitter and XTP R HD 4K Receiver • Installation
on page 13) and connect an XTP power injector to the
SIG LINK
OVER XTP
AUDIO
ON RS-232 IR
L R RESET
OFF
+ −
+ − Tx Rx G Tx Rx XTP OUT
LAN
Shielded
Twisted Pair
Cable
100-240V 50/60 Hz
Power ---A MAX
XTP XTP PWR
PWR
Extron
XTP PI 100
REMOTE
XTP Power POWER
Injector
SIG LINK
POWER
12V
1.1A MAX
+ -
XTP IN LAN
Extron
XTP R HD 4K
XTP Receiver
OVER XTP
OUTPUTS RELAYS
AUDIO AUDIO
1
RS-232 IR L R 2
ON
OFF
+ - + -
HDMI S/PDIF
Tx Rx G Tx Rx
www.extron.com
XTP R HD 4K
RESET
for
15