Power Supply Wiring
NOTES:
Figure 10 shows how to wire the connector. Snap the provided ferrite bead onto the DC
power cable, between the power supply and the connector on the DVI unit.
Figure 10.
CAUTION: Risk of minor personal injury.
ATTENTION : Risque de blessure mineure.
•
Only one power supply is required. A single power supply connected to either unit
in the pair powers both units (see
•
A power supply is included with each individually-packaged transmitter.
3/16"
(5 mm) Max.
Smooth
Ridges
A
A
Captive Screw
SECTION A–A
Power Supply
Output Cord
Power Connector Wiring
•
The two power cord wires must be kept separate while the power supply is
plugged in. Remove power before wiring.
•
Les deux cordons d'alimentation doivent être tenus à l'écart l'un de l'autre quand
l'alimentation est branchée. Couper l'alimentation avant de faire l'installation
électrique.
DTP DVI 4K 230 D Transmitter and Receiver • Installation and Operation
Ground Loops
on page 15).
Connector
11