Table of Contents
Advertisement
Power Supply Wiring
NOTES:
Figure 10 shows how to wire the power connector. Snap the provided ferrite bead onto the
DC power cable, between the power supply and the connector on the HDMI unit.
A
Figure 10.
CAUTION: The wires must be kept separate while the power supply is plugged in.
ATTENTION : Les deux cordons d'alimentation doivent être tenus à l'écart l'un de
•
Only one power supply is required. A single power supply connected to either unit
in the pair powers both units.
•
A power supply is included with each individually-packaged transmitter.
•
Do not tin the power supply leads before installing them in the direct insertion
connector. Tinned wires are not as secure in the connectors and could be pulled
out.
3/16"
(5 mm) Max.
Smooth
Ridges
A
Captive Screw
Connector
SECTION A–A
Power Supply
Output Cord
Power Connector Wiring
Remove power before wiring.
l'autre quand l'alimentation est branchée. Couper l'alimentation avant de faire
l'installation électrique.
DTP HDMI 4K D Series Transmitter and Receiver • Installation and Operation
11
Advertisement
Table of Contents
