Siemens 7SJ82 Manual page 1111

The following table shows the result of the switching-authority check, based on the set switching authority
and the cause of the command. This overview represents a simplified normal case (no multiple command
sources when using Station and Remote).
Table 8-20
Cause Source
Local
Station
Remote
Local automatic
operation
Station automatic
operation
Remote automatic
operation
DIGSI
Specific Switching Authority
Special switching authorities can be configured as extension of the switching-authority check. This makes it
possible to differentiate the Remote command sources at the bay level. Switching authority can be routed to
or revoked from different control centers that can, for example, belong to different companies. Thus, precisely
one of these command sources can switch at a certain time. This function is based on extending the
switching-authority check by verifying the identifier of the command source (field Originator/orIdent of
switching command). In order to turn on the function, go to General/Control and set the check mark for the
parameter Specific sw. authorities. More settings for the configuration of the identifiers and the
behavior of the function as well as additional signals appear (see
command source to switch, you must activate this specific switching authority. In order to do this, set the
controllable Enable sw. auth. 1 to Enable sw. auth. 5.
SIPROTEC 5, Overcurrent Protection, Manual
C53000-G5040-C017-8, Edition 07.2017
Result of a Switching-Authority Check
Switching Authority
Local
Release
Blocked
Blocked
Release
Blocked
Blocked
Blocked
DIGSI Station
Blocked Blocked
Blocked Release
Blocked Blocked
Release Release
Blocked Release
Blocked Blocked
Release Blocked
Figure
Control Functions
8.3 Control Functionality
Remote
Blocked
Blocked
Release
Release
Blocked
Release
Blocked
8-33). In order to permit an additional
1111