Planmeca Promax 3D s User Manual page 93

Positioning controls
Positioning joystick
(x / y coordinates)
Rotate C-arm
clockwise
User's Manual (2D)
To adjust the position of the target area, move the
positioning joystick crosswise (x coordinate) or lengthwise
(y coordinate) until the cross formed by the light beams is
at the correct position for the exposure you wish to take.
The coordinates of the selected position are shown on the
main display.
Note that, if necessary, you can rotate the C-arm 90
degrees clockwise by touching the 90° field on the control
panel. This might give you a better view to the patient.
Touching the 90° field again will rotate the C-arm back to
the original position.
Rotate C-arm
To adjust the angle of the C-arm, press either of the C-
counterclockwise
arm rotation buttons. Pressing the button on the left will
rotate the C-arm clockwise, and pressing the button on
the right will rotate the C-arm counterclockwise.
The C-arm angle is shown on the main display.
Planmeca ProMax & Planmeca ProMax 3D s / 3D 89
TOMOGRAPHIC EXPOSURE
Tomographic
positioning lights
Thumb wheel