Planmeca Promax 3D s User Manual page 33

Quick buttons
8.2.3 Changing exposure values for quick buttons
8.2.4 Selecting patient entry position
User's Manual (2D)
The Select kV / mA display appears. Select the required
exposure values by touching the kV and mA values. The
selected values will be highlighted.
Confirm your selection and return to the main display by
touching OK.
The preset exposure values for the selected exposure
program are shown in the quick buttons at the bottom of
the display.
NOTE Selecting kV and mA values manually will override the
automatic quick button setting.
The quick button exposure values have been preset at the
factory. If needed, the preset values can be changed by
the user.
To change the preset values of a quick button, first select
the required kV and mA values by touching the
corresponding fields on the parameter display and then
touch and hold the desired quick button at the bottom of
the display until you hear a signal tone. The quick button
will now show the new exposure values.
The quick button values are program-specific, i.e. the
exposure values can be set separately for each program.
NOTE To view the preset exposure values for each program
type, refer to the tables in chapters 12 "PANORAMIC
EXPOSURE" on page 62, 13 "TEMPOROMANDIBULAR
JOINT (TMJ) EXPOSURE" on page 69 and 14 "SINUS
EXPOSURE" on page 80.
Confirm your selection and return to the main display by
touching OK.
SCARA 3 units offer two patient entry positions: Entry 1
and Entry 2. You can use either of them according to your
individual preference.
Selecting Go Entry 1 will move the C-arm to the back,
away from the patient positioning area. This full view
position allows you to monitor and adjust the patient's
position freely from all directions.
Selecting Go Entry 2 will position the C-arm around the
temple supports. This is the traditional closed patient
entry position.
NOTE If needed, the Go Entry 1 function can be disabled as
described in section "Behavioural preferences (i230)"
on page 45. This might be necessary if there is no
space for the C-arm to move back.
Planmeca ProMax & Planmeca ProMax 3D s / 3D 29
CONTROL PANEL