User's Manual (2D)
On the Enable / disable features display, touch the feature
you wish to activate. Enabled features will be marked with
a green check mark. Confirm the selection by touching
Done.
By touching the down arrow at the bottom of the display
more features will appear. On the next displays, touch the
up arrow to return to the previous display.
You will need a license code to add a new feature to the
X-ray unit. The license code can be a specific code for the
selected feature on this X-ray unit or a general code.
Touch the feature field (e.g. Horizontal and vertical
segmenting) to switch this feature on. A number display
will appear. Enter the license code to enable the selected
feature.
NOTE FOR SPECIFIC LICENSE CODES:
Each license code is unit and module specific, i.e. it
can only be used on the specified X-ray unit and for the
specified program feature.
To disable the selected feature repeat the procedure.
NOTE After enabling / disabling a new feature the X-ray unit
must be restarted.
Planmeca ProMax & Planmeca ProMax 3D s / 3D 51
INFORMATION DISPLAYS