Changing The Engine Oil And Oil Filter, Cleaning The Oil Screen - Husqvarna FC 250 Owner's Manual

17 SERVICE WORK ON THE ENGINE
17.3
118

Changing the engine oil and oil filter, cleaning the oil screen

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Check the O-rings for damage.
Replace damaged O-rings.
Drain the engine oil while the engine is at operating temperature.
120299-10
F00090-10
F00091-10
Preparatory work
–
Park the motorcycle on a level surface.
Main work
–
Place a suitable container under the engine.
–
1
Remove oil drain plug
Info
Do not remove screws
–
3
Remove screw plug with oil screen
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
–
4
Position oil screen with the O-rings on a pin wrench.
–
Position the pin wrench through the drilled hole of the screw
plug in the opposite section of the engine case.
–
Push the oil screen all the way into the engine case.
with the magnet and seal ring.
2
.
4
.