Lubricating The Steering Head Bearing; Removing The Start Number Plate; Installing The Start Number Plate; Removing Front Fender - Husqvarna FC 250 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.13
11.14
11.15
11.16
54

Lubricating the steering head bearing

H02387-01

Removing the start number plate

F00049-10

Installing the start number plate

F00050-10

Removing front fender

–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated
in the course of removal and installation of the lower
triple clamp.
–
1
Remove screw . Swivel the start number plate to one side.
–
2
Remove screw and take off the brake line guide and start
number plate.
–
Position the brake line and brake line guide on the start num-
ber plate.
–
Mount and tighten screw
–
Position the start number plate.
The holding lugs engage in the fender.
–
Mount and tighten screw
Preparatory work
–
Remove the start number plate. (
( p. 49)
( p. 50)
1
.
2
.
p. 54)