Handlebar Position; Adjusting The Handlebar Position - Husqvarna FC 250 Owner's Manual

10 TUNING THE CHASSIS
10.16
10.17
44

Handlebar position

H01188-10

Adjusting the handlebar position

H01189-11
Guideline
Rebound damping
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counter-
clockwise to reduce damping.
–
1
Mount protection cap
The holes on the handlebar supports are placed at a distance
A
of from the center.
Hole distance A 3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. In this
way, the handlebar can be mounted in the most comfortable
position for the rider.
Preparatory work
–
Remove the handlebar cushion.
Main work
–
1
Remove screws . Take off the handlebar clamp. Take off
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
2
Remove screws . Take off handlebar supports
–
Position rubber bushings
below.
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
Screw, handle- M10
bar support
–
Position the handlebar.
17 clicks
12 clicks
7 clicks
.
3
.
4 5
and push through nuts
2
.
40 Nm (29.5 lbf ft)
®
Loctite
from
243™