Run Mode - Graco PCF Instructions - Parts Manual

Run Mode

Run mode screens are divided into four sections: home,
error reports, job reports, and preventative mainte-
nance. While in Setup mode press
mode. Press
mode screens.
Home Screens
There are two home screens: one for the fluid plate and
one for the control center. Press
through the home screens.
Home Screen 1 - Fluid Plate
This screen displays the current dispense control mode
used, the current pressure, and the current style being
dispensed. It also displays the target dispense volume,
the actual dispense volume, and the requested dis-
pense volume.
Command Voltage
(Displays only when
Command Cable or
Gateway is selected as
the Command Value
Source; see Fluid Plate
Setup Screens, page
91.)
Inlet Pressure
(non-heated systems)
Flow Rate
(systems with flow
meters)
313377L
to enter Run
to navigate through the Run
to scroll
Appendix A - Advanced Display Module (ADM)
From this screen users can adjust the bead scale and
enter maintenance mode. Press
change the bead scale. Press
nance mode.
The PCF system has two operating modes:
• Dispense mode – enables the module to begin dis-
pensing when it receives a command from the auto-
mation unit.
• Maintenance mode – enables the module to begin
dispensing when the user presses the manual dis-
pense button. Dispense parameters and duration
depend on the selected control.
Dispensing continues for as long as the manual dis-
pense button
and
to enter mainte-
is pressed.
Current Dispense
Control Mode
Current Command
Value
Outlet Pressure
to
95