Graco PCF Instructions - Parts Manual page 106

Appendix C - Communications Gateway Module (CGM) Connection Details
EtherNet/IP
NS
F . 59: EtherNet/IP Fieldbus Connections
IG
The Ethernet interface operates at 100Mbit, full duplex,
as required by PROFINET. The Ethernet interface is
auto polarity sensing and auto-crossover capable.
Network Status (NS)
State
Off No power or no IP address
Green On-line, one or more connections established
(CIP Class 1 or 3)
Flashing On-line, no connections established
Green
Red Duplicate IP address, FATAL error
Flashing One or more connections timed out (CIP Class
Red 1 or 3)
Module Status (MS)
State
Off No power
Green Controlled by a Scanner in Run state
Flashing Not configured, or Scanner in Idle state
Green
Red Major fault (EXCEPTION-state, FATAL error
etc.)
Flashing Recoverable fault(s)
Red
LINK/Activity (Link)
State
Off No link, no activity
Green Link established
Flashing Activity
Green
106
MS
Link
TI11814A
Description
Description
Description
DeviceNet
NS
1 2
F . 60: DeviceNet Fieldbus Connections
IG
Network Status (NS)
State
Off Not online / No power
Green On-line, one or more connections are
established
Flashing On-line, no connections established
Green
(1 Hz)
Red Critical link failure
Flashing One or more connections timed-out
Red (1 Hz)
Alternating Self test
Red/Green
Module Status (MS)
State
Off No power or not initialized
Green Initialized
Flashing Missing or incomplete configuration, device
Green (1 Hz) needs commissioning
Red Unrecoverable Fault(s)
Flashing Recoverable Fault(s)
Red (1 Hz)
Alternating Self test
Red/Green
DeviceNet Connector (DC)
Pin Signal
1 V- Negative bus supply voltage
2 CAN_L CAN low bus line
3 SHIELD Cable shield
4 CAN_H CAN high bus line
5 V+ Positive bus supply voltage
MS
3 4 5
TI11815A
DC
Description
Description
Description
313377L