Appendix A - Advanced Display Module (ADM)
Gateway Setup Screens
NOTE: The Gateway Setup screens are not available
if a Discrete Gateway Module is attached to the sys-
tem.
There are up to three Gateway Setup screens (depend-
ing on fieldbus), which enable users to set or change
information regarding the Gateway module used on the
PCF system. These screens also enable users to view
information regarding the particular Gateway module
used.
Press
to scroll through the Gateway Setup
screens. Once in the desired Advanced Setup screen,
press
to access the fields to make changes. Press
to exit edit mode.
NOTE: Users must be out of edit mode to scroll
through the Gateway Setup screens.
Gateway Setup Screen 1 - DeviceNet
This screen enables users to set the device address and
the baud rate. The DeviceNet screen displays the hard-
ware revision number, system serial number, map ID,
name, revision number, and install date.
88
Gateway Setup Screen 1 - EtherNet/IP
This screen enables users to set the IP address, subnet
mask, Gateway, DNS 1, DNS 2, and if a DHCP is used.
Gateway Setup Screen 2 - EtherNet/IP
This screen is the same for EtherNet/IP and PROFI-
BUS. It enables users to view the following information
regarding the Gateway module used on the PCF sys-
tem:
•
hardware revision number
•
system serial number
•
map ID number
•
map name
•
map revision number
•
date the map was created
313377L