Graco PCF Instructions - Parts Manual page 24

Installation
Discrete Gateway Module
Module Description
The Discrete Gateway Module (DGM) provides a control
link between the PCF system and an automation con-
troller through discrete input and output connections.
This provides the means for remote monitoring and con-
trol by external automation systems.
See Automation Control (Normal) Operation, page
37, for details on controlling the PCF system through the
Gateway module.
Connect D-Sub Cable
The DGM provides all I/O through the D-Sub cable.
Graco offers two options for connecting a D-Sub cable
to the D-Sub connector (CG). Both options are accesso-
ries and must be ordered separately.
• D-Sub to flying leads cable (123793). See
Appendix B - Discrete Gateway Module
(DGM) Connection Details, page 98, for
details and cable interface signals.
• D-Sub cable (123972) and 78-pin breakout
board (123783). See Appendix B - Discrete
Gateway Module (DGM) Connection Details,
page 98, for details and pin assignments.
CG
F . 15: Connect D-Sub Cable
IG
DGM Status LED Signals
See LED Diagnostic Information, page 54, for signal
definitions.
24
r_24B681_2B9904_2b
313377L