Errors; View Errors; Diagnose Errors; Clear Errors And Reset Control Unit - Graco PCF Instructions - Parts Manual

Errors

View Errors

When errors occur the highest priority active error is dis-
played in the menu bar. The previous 140 errors are dis-
played on the error report screens. See Run Mode,
page 95, for instructions on navigating to and through
the error report screens.
Error
Code

Error Codes and Troubleshooting

NOTE: Error codes are stored in the error log, and displayed on the error report screens. Gateway error num-
bers are reported over the Gateway interface.
Error Gateway
Code Error No. Error Name
0000 0 No Active Errors
EP0X 1 Power Up
EC0X 2 Setup Values
Changed
313377L
Error
Description
System Errors
No errors n/a
Control box power up Record only
Setup change notifica- Record only
tion
There are three levels of errors: alarms, deviations, and
advisories. Alarms are critical and require immediate
correction; therefore, the system automatically shuts
down. Deviations are critical and require attention but
not immediately. Advisories are not critical but still
require attention.
NOTE:
• Alarms set the dispenser ready signal LOW.
• Advisories and deviations do not set the dispenser
ready signal LOW.

Diagnose Errors

See Error Codes and Troubleshooting for valid error
codes, possible causes, and solutions.
Clear Errors and Reset Control
Unit
Press to clear an error before restarting the control
unit.
Error Type Cause
n/a
n/a
A setup value was
changed on the dis-
play
Errors
Solution
No action necessary
No action necessary
No action necessary if
changes were desired
55