Configure Errors - Graco PCF Instructions And Parts

5. Set the desired minimum and maximum pressure
limits for the inlet, and the desired maximum pres-
sure limit for the outlet.
6. Set the error type (alarm or deviation) that will be
issued:
• If the minimum inlet pressure decreases below
the setting.
• If the maximum inlet pressure increases above
the setting.
• If the maximum outlet pressure increases above
the setting.
7. Press to exit edit mode.
313377B

Configure Errors

Set the error type (alarm or deviation) that will be issued
if the pressure, flow rate, volume, or computed target
goes outside the set high and/or low limits. See Jobs,
page 40, for information on the purpose of each error
type.
NOTE: Only the first two error types (low pressure
and high pressure) will be enabled for systems with-
out a flow meter.
1. With the system in setup mode, navigate to the Fluid
Plate set of screens.
2. Press to scroll to the Error Type screen
(screen 6).
3. Press to access the fields to make changes.
F . 27
IG
4. Press to open the Low Pressure drop-down
list, and select either Alarm or Deviation for the error
type. Press to enter the selection.
5. Press to move to the next field. Repeat Step 4
for each field.
6. Press to exit edit mode.
System Setup
33