Demonstrating The Alarms - ZOLL WCD 3100 Training Manual

LifeVest System WCD 3100 Training Manual

Demonstrating the alarms

Demonstrate the alarms to help the patient learn how to respond. Follow the
procedures below to:
Place the system in training mode, then
Simulate alarm conditions.
How to enter training mode
Page 3-4
View the navigation buttons from the top of the monitor with the
display facing you.
1 Remove and reinsert the battery.
2 While the opening screen is displayed, hold the response
buttons and hold ◄ at the same time. Continue holding these
buttons until the screen changes.
This screen may be displayed for more than 10 seconds.
3 Press ▲ or ▼ to choose a language, then press ►.
Note: The language you choose only affects the setup
screens and will not affect the patient screens.
ZOLL Lifecor internal use only