ZOLL WCD 3100 Training Manual page 14

LifeVest System WCD 3100 Training Manual
How to demonstrate a noise alarm
Page 3-8
1 With this screen displayed, press ▲.
2 Tell the patient what to do when the gong alarm sounds:
Read the display. This particular message states that
ECG signal is not clear. The ECG electrodes are not
sending a good signal to the monitor.
Take action to correct problem. In this case, adjust the
belt so that the ECG electrodes make better contact with
the skin.
Press response buttons if display so states. This stops
the gong alarm.
3 With a noise alarm, when you press the response buttons,
the monitor checks for an improvement in the ECG signal.
For the demonstration, the ADJUST BELT message returns.
4 After three cycles, the monitor displays this message.
When this happens, the patient is expected to check the belt.
Pressing the response buttons does not make this message
go away.
5 To stop the noise alarm demonstration, press ▲.
ZOLL Lifecor internal use only