ZOLL WCD 3100 Training Manual page 27

If you get an error message when sending data
ZOLL Lifecor internal use only
3 Data will be sent and you will see these messages.
If you get an error message, see the chart below.
4 When the transfer is complete, disconnect the modem from the
monitor. Disconnect the phone line from the modem.
The monitor resumes normal operation.
Message What it means What to do
Phone line is busy. Disconnect the modem connector from
the monitor. Wait a few minutes. Then
reconnect the monitor.
Data could not be sent. Check modem connections. Disconnect
the modem. Then reconnect the modem
in the order described: Connect the
phone first, then the monitor.
If you continue to get this message,
make sure your phone service is
working.
There was no answer at Disconnect the modem from the
the receiving end. monitor. Wait a few minutes. Then
reconnect the modem.
If you continue to get this message,
make sure your phone service is
working.
Data transfer was Disconnect the modem from the
interrupted. monitor. Wait a few minutes. Then
reconnect the modem. If problems
continue, wait a few minutes and try
again.
Data could not be sent. Disconnect the modem from the
An error code will monitor. Wait a few minutes. Then
appear. reconnect the modem. If problem
continues, write down the error code,
then contact ZOLL Lifecor.
Other procedures
Page 5-3