ZOLL WCD 3100 Training Manual page 44

LifeVest System WCD 3100 Training Manual
How to put the monitor in setup mode
Before doing any of the monitor setups described in this section, follow this
procedure to put the monitor in setup mode.
Page B-6
1 Remove and reinsert the battery.
2 While the opening screen is displayed, hold the response buttons and
hold ◄ at the same time. Continue holding these buttons until the
screen changes.
This screen may be displayed for more than 10 seconds.
3 Press ▲ or ▼ to choose a language, then press ►.
Note: The language you choose only affects the setup screens and
will not affect the patient screens.
4 The main menu displays, showing that the monitor is in setup mode.
You may now proceed to program the monitor.
5 When you are finished programming the monitor, do one of the
following:
Navigate back to the main menu, select EXIT, then press ►.
Wherever you are in any menu, remove and reinsert the battery.
ZOLL Lifecor internal use only