ZOLL WCD 3100 Training Manual page 50

LifeVest System WCD 3100 Training Manual
Dialer menu and settings
Menu Menu option
Patient dial prefix
Patient dialing number
Patient dialer mode
Hospital dial prefix
Hospital dialing
number
Hospital dialer mode
About dialing modes
To transfer data from home, using the patient dialer settings, the patient simply
connects the phone line to the modem, then connects the modem to the monitor.
To transfer data using the hospital dialer settings, hold ► when connecting the
modem to the monitor. Hold the button until you see the CHECKING MODEM
message. In this case the monitor uses the hospital dialer settings that have
been programmed into it.
Phone number example
Page B-12
What it means
Prefix number that may be required
to dial out from primary location
(see example below). For example,
you may need to dial 9 to reach an
outside line. That number 9 is the
dial prefix and it is dialed before
the dialing number.
Phone number that will be called to
download data from monitor using
the modem. This is a complete
number with area code and phone
number.
Type of phone used to download
data.
If using a secondary location, prefix
number that may be required to
dial out.
If using a secondary location, the
phone number that will be called to
transmit data from monitor using
the modem.
Type of phone used to download
data.
1 Dial prefix (precedes any phone numbers)
2 Pause (each comma equals 1 second)
3 Dialing number
How to select
Select any number, based on what
is required. If any pauses are
required, each comma equals
1 second.
Determined by device provider and
does not normally need to be
changed. Contact ZOLL Lifecor for
assistance before changing this
setting.
Tone or pulse.
Select any number, based on what
is required. If any pauses are
required, each comma equals
1 second.
Determined by device provider and
does not normally need to be
changed. Contact ZOLL Lifecor for
assistance before changing this
setting.
Tone or pulse.
ZOLL Lifecor internal use only