14. DMX Output: For DMX512 link, use 3-pin XLR plug cable to link the next unit.
Please refer to the following diagram to address your DMX512 channel for the first 4 units:
15. Only for remote control: Connect with CA-8 to control the unit for Stand by, Function and
Mode function.
3.2 Main Function
To select any functions, press the MENU button until the required one is shown on the
display. Select the function by the ENTER button and the display will blink. Use the DOWN
and UP button to change the mode. Once the required mode has been selected, press the
ENTER button to setup or it will automatically return to the main functions without any
change after idling one minute. Back to the functions without any change press the MENU
button.
The main functions are shown below:
13B
6B