Advertisement
6. DMX 512 Connections
1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter-cable.
2. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm
1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in
the DMX-output of the last unit.
3. Connect the unit together in a `daisy chain` by XLR plug from the output of the unit to the
input of the next unit. The cable can not branched or split to a `Y` cable. DMX 512 is a
very high-speed signal. Inadequate or damaged cables, soldered joints or corroded
connectors can easily distort the signal and shut down the system.
4. The DMX output and input connectors are pass-through to maintain the DMX circuit,
when one of the units' power is disconnected.
5. Each lighting unit needs to have an address set to receive the data sent by the controller.
The address number is between 0-511 (usually 0 & 1 are equal to 1).
6. The end of the DMX 512 system should be terminated to reduce signal errors.
7. 3 pin XLR connectors are more popular than 5 pin XLR.
15B
2. Technical Specifications
◇ Equipped with 36pcs of 3W R,G,B,W LEDs, creating powerful multi beam effect.
◇ Three Operation Modes: DMX, Master/Slave, Sound Active.
◇ DMX CH modes: 4/5/7CH selectable.
◇ Beam Angle: 13.5°
◇ Spectacular built-in programs under master/salve operation, triggered by music.
◇ 0-100% full range dimmer and variable strobe speed.
◇ Optional easy controller CA-8 for instant lighting shows at your fingers.
◇ Ideal for rental, clubs, bars, discos, parties, mobile DJs and more.
◇ Input Voltage:
AC 100V~240V, 50/60Hz
◇ Power Consumption:
99W
◇ Light Source:
36pcs×3W RGBW LEDs
(Red: 8pcs; Green: 10pcs; Blue: 10pcs; White: 8pcs)
◇ Fuse:
T 6.3A
◇ Dimension:
260 × 195 × 293mm
◇ Weight:
4Kgs
4B
Hide quick links:
Advertisement
