Parameter description
3.2.1 Password Input
CP.00
Password Input
Ex works the frequency inverter is supplied without password protection, this means that all changeable parameters
can be adjusted. After parameterizing the unit can be barred against unauthorized access (Passwords: see last
but one page). The adjusted mode is stored.
Barring the CP-Parameter
Enabling the CP-Parameter
3.2.2 Operating Display
The parameters below serve for the controlling of the frequency inverter during operation.
CP.01
Actual frequency display
Co-domain
0...±400 Hz
18.3
-18.3
CP.02
Set frequency display
Co-domain
0...±400 Hz
CP.03
Inverter status
The status display shows the actual working conditions of the inverter. Possible displays and their meanings are:
Display
noP
LS
FAcc
FdEc
Description
Display of the actual output frequency in Hz. Additionally the operator display "noP" and
"LS", even if the control release or direction of rotation are not switched (see CP.3). The
rotation of the inverter is indicated by the sign.Examples:
Output frequency 18,3 Hz, rotation forward
Output frequency 18,3 Hz, rotation reverse
Description
Display of actually set value. For control reasons the set speed is displayed, even if the
control release or direction of rotation are not switched. If no direction of rotation is set,
the set speed for clockwise rotation (forward) is displayed.
Status
„no Operation" control release not bridged; modulation switched off; output voltage = 0 V; drive
is not controlled.
„Low Speed" no direction of rotation preset; modulation switched off; output voltage = 0 V; drive
is not controlled.
"Forward Acceleration" drive accelerates with direction of rotation forward.
„Forward Deceleration" drive decelerates with direction of rotation forward.
ENTER
Password
UP
FUNC
ENTER
Password
UP
FUNC
further on next side
GB - 13