KEB COMBIVERT F5 Series Instruction Manual page 24

Parameter description
CP.33 Relay output 2 / switching level
Co-domain
-30000,00...30000,00
CP.34 Source of rotation direction
Description
The source rotation setting and the mode of evaluating the rotation setting is defined with this parameter. With
CP.34 one does not modify the rotation source of the fixed frequencies (CP.19...21). The settings must be
confirm by „ENTER".
Value Setting
0...1
2 x
3
4
5
6
7
8...9
GB - 24
Setting Description
4,00 This parameter determines the switching level for the relay output 2
(CP.32). After the switching of the relay, the value can move within a
window (hysteresis), without the relay dropping off. Since the operator
can display only 5 characters, the last digits are not represented in the
case of higher values.
Output variable Hysteresis
Frequency 0,5 Hz
Actual DC voltage 1 V
Analog set value 0,5 %
Active current 0.5 A
Temperature 1 °C
direction of rotation
Only application mode
Setting by way of terminal strip forward/reverse; negative values are set to zero
Setting by way of terminal strip forward/reverse; the sign of the set point values have no effect
on direction of rotation.
Setting by way of terminal strip run/stop (X2A.14) and forward/reverse (X2A.15); negative
values are set to zero
Setting by way of terminal strip run/stop (X2A.14) and forward/reverse (X2A.15); the sign of
the set point values have no effect on direction of rotation.
Set value dependent; positive value = clockwise rotation; negative value = counterclockwise
rotation. Status "Low speed" (LS) if no terminal For or Rev is active.
Set value dependent; positive value = clockwise rotation; negative value = counter clockwise
rotation; clockwise rotation is indicated if set value is "0"
Only application mode
Setpoint 0-limited (value 2 and 4)
intern
100%
-100%
-100%
-10V
10V
extern
100%
-10V
Setpoint absolute (value 3 and 5)
intern
100%
-100% 100%
-100%
10V
extern