Canon iPF6100 Service Manual page 143

Setting Item
[Interfac [EOP Timer]
e Setup]
[TCP/IP] [IPv4] [IPv4 Mode]
[Protocol]
[IPv4 Settings] [IP Address]/
[DNS Settings] [DNS Dync
[IPv6] [IPv6 Support]
[IPv6 StlessAddrs]
[DHCPv6]
[DNS Settings] [DNS Dync
[NetWare] [NetWare]
[Frame Type]
[Print Service]
[AppleTalk]
[Ethernet [Auto Detect]
Driver]*12
[Comm.Mode]
[Ethernet Type]
[Spanning Tree]
[MAC Address]
[Interface Print]
[Return Defaults]
T-1-86
Description/Instructions
Specify the timeout period before cancellation of print jobs that
cannot be received by the printer.
Choose whether the printer IP address is configured
automatically or a static IP address is entered manually.
[DHCP]/ Specify the protocol used to configure the IP address
[BOOTP]/ automatically.
[RARP]
Specify the printer network information when using a static IP
[Subnet Mask]/ address.
[Default G/W] Enter the IP address assigned to the printer, as well as the
network subnet mask and default gateway.
Specify whether DNS server registration is updated
update] automatically.
[Pri. DNS Specify the DNS server address.
SrvAddr]/[Sec.
DNS SrvAddr]
[DNS Host Specify the DNS host name.
Name]
[DNS Domain Specify the DNS domain name.
Name]
Set whether to support IPv6 connection.
Set whether to use IPv6 stateless address.
Set whether to use DHCPv6 setting.
Specify whether DNS server registration is updated
update]- automatically.
[Statefull
Addr]/
[Stateless
Addr]
[Pri. DNS Specify the DNS server address.
SrvAddr]/[Sec.
DNS SrvAddr]
[DNS Host Specify the DNS host name.
Name]
[DNS Domain Specify the DNS domain name.
Name]
Specify the NetWare protocol. To apply your changes, choose
Register Setting.
Specify the frame type to use.
Choose the print service.
Specify whether to use the AppleTalk protocol. To apply your
changes, choose Register Setting.
Specify the communication method. To apply your changes,
choose Register Setting.
Choose On for automatic configuration of the LAN
communication protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported over the
LAN.
Displays the MAC address.
Print the interface settings.
Select [OK] to return the [Interface Setup] settings to factory
default.
Chapter 1
1-125