Canon iPF6100 Service Manual page 105

[Interface Setup]
[EOP Timer]
[TCP/IP] [IP Mode]
[Protocol]
[IP Setting]
[NetWare] [NetWare]
[Frame Type]
[Print Service]
[AppleTalk]
[Ethernet Driver] [Auto Detect]
[Comm.Mode]
[Ethernet Type]
[Spanning Tree]
[MAC Address]
[Ext.Interface]
[Init. Settings]
[Maintenance]
[Maint. cart.]
[Replace P.head]
[Move Printer]
[Clean Platen]
[Spur Cleaning]
Setting Item
[DHCP]
[BOOTP]
[RARP]
[IP Address]
[Subnet Mask]
[Default G/W]
Setting Item
T-1-44
Description, Instructions
Specify the timeout period for print jobs.
Choose whether the printer IP address is configured automatically or a static IP address is
entered manually.
Specify the protocol used to configure the IP address automatically.
Specify the printer network information when using a static IP address.
Enter the IP address assigned to the printer, as well as the network subnet mask and default
gateway.
Specify the NetWare protocol. To apply your changes, choose Store Setting .
Specify the frame type to use.
Choose the print service.
Specify whether to use the AppleTalk protocol. To apply your changes, choose Store Setting .
Specify the communication method. To apply your changes, choose Store Setting .
Choose On for automatic configuration of the LAN communication protocol. Choose Off to use
settings values of Comm.Mode and Ethernet Type .
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported over the LAN.
Displays the MAC address.
When installing the expansion interface board, choose whether the expansion interface board is
used.
A confirmation message is displayed if you press the
network settings to the default values.
T-1-45
Description, Instructions
When exchanging the maintenance cartridge, choose Yes and follow the instructions on the
screen.
Not displayed during a warning message that the remaining Maintenance Cartridge capacity is
low.
When replacing the Printhead , choose Yes and follow the instructions on the screen.
Not displayed during a warning message that the remaining Maintenance Cartridge capacity is
low.
When transferring the printer to another location, choose Yes and follow the instructions on the
screen.
Use this function to clean inside the Top Cover . After you select Yes , the Carriage is moved
in preparation for Platen cleaning.
Choose Yes to clean the spur. Use the cleaning sheet come with the printer.
Chapter 1
button. Choose [OK] to restore the
1-87