Canon iPF6100 Service Manual page 461

J1101 (Connect to HDD expansion PCB)
Pin Number Signal name
82 +3.3V
83 +3.3V
84 +3.3V
85 GND
86 GND
87 GND
88 GND
J1201 (Network)
Pin Number Signal name
1 TX+
2 TX-
3 RX+
4 -
5 -
6 RX-
7 -
8 -
9 GREEN_LED_C
10 GREEN_LED_A
11 YELLOW_LED_C
12 YELLOW_LED_A
J1801 (Connect to Power supply)
Pin Number Signal name
1 HD1_VHFBH
2 HD1_VHFBG
3 VH
4 GND
5 VH
6 GND
7 RGV20(VCC)
8 GND
9 VM
10 GND
11 VM
12 GND
13 VH_ENB
14 PW_CONT
J2511 (Spur motor, Spur cam sensor, Mist fan, Cutter motor, Cutter right detection sensor)
Pin Number Signal name
1 SNS_3V_1
2 GND
3 CUTTER_R_SNS_R
4 CUTTER_OUTA
5 CUTTER_OUTB
6 SNS_3V_1
7 GND
8 HAKUSHA_CAM_SNS_R
9 HAKUSHA_MOTOR_AM
10 HAKUSHA_MOTOR_AP
11 FAN_VM
12 MIST_FAN_LOCK
13 MIST_FAN_PWM
14 GND
IN/OUT Function
OUT Power supply (+3.3V)
OUT Power supply (+3.3V)
OUT Power supply (+3.3V)
- GND
- GND
- GND
- GND
T-6-47
IN/OUT Function
OUT Ethernet data TX line (+)
OUT Ethernet data TX line (-)
IN Ethernet data RX line (+)
- Not used
- Not used
IN Ethernet data RX line (-)
- Not used
- Not used
OUT Link LED (green:100Mb/s) cathode terminal
OUT Link LED (green:100Mb/s) anode terminal
OUT Link LED (yellow:10Mb/s) cathode terminal
OUT Link LED (yellow:10Mb/s) anode terminal
T-6-48
IN/OUT Function
OUT VH feedback voltage +
OUT VH feedback voltage -
IN Power supply (+21.5V)
- GND
IN Power supply (+21.5V)
- GND
IN Power supply (+21.5V)
- GND
IN Power supply (+26V)
- GND
IN Power supply (+26V)
- GND
OUT VH power supply ON/OFF signal
OUT Normal/power saving switch signal
T-6-49
IN/OUT Function
OUT Power supply (+3.3V)
- GND
IN Cutter right detection sensor signal
OUT Cutter motor driver signal A
OUT Cutter motor driver signal B
OUT Power supply (+3.3V)
- GND
IN Spur cam sensor output signal
OUT Spur motor drive signal AM
OUT Spur motor drive signal AP
OUT Power supply (+26V)
IN Mist fan lock signal
OUT Mist fan duty control signal
- GND
Chapter 6
6-37