Hd-Sdi Input Module (Optional) - Barco DP2K-36BLP User And Installation Manual

8. Input & communication
8.4

HD-SDI Input Module (optional)

Depending on the projector configuration the projector card cage is either equipped with an ICP or ICMP. In
case an ICP is installed then an IMB, IMS, or HDSDI input module can be optionally inserted into the slot below
the ICP. This is not the case if the ICMP is installed. For more information about the ICMP see chapter called
ICMP.
Location of the source input ports
Image 8-4
1 SMPTE 292/424 input, port A (maximum cable length of 30 m allowed)
2 SMPTE 292/424 input, port B (maximum cable length of 30 m allowed)
SMPTE
Society of Motion Picture and Television Engineers - A global organization, based in the United States, that sets stan-
dards for baseband visual communications. This includes film as well as video standards.
HD-SDI settings
Port Port type
A or B HDSDI Single link 4:2:2 10
3GSDI link
82
Source: 2K
General settings
Mode Scan type
Progressive
bits/color
Progressive - field bit
normal
Progressive - field bit
inverted
Progressive SF - 2nd
field dominant
Progressive SF - 1st
field dominant
4:2:2 12 Progressive
bits/color
4:4:4 10 Progressive
bits/color
4:4:4 12 Progressive
bits/color
1
SMPTE 292/424 IN
A
Advanced settings
Color Pixel mapping
space
YCbCr HDSDI-Single link
YCbCr 3G-level A-Single link
3G-level B-Dual link
RGB 3G-level A-Single link
3G-level B-Dual link
XYZ/RGB 3G-level A-Single link
3G-level B-Dual link
R5906753 DPXK BLP SERIES 20/11/2017
2
B
SEL
SEL
SYNC OK
SYNC OK
Calibration
Single
Single