Table of Contents
Advertisement
7.4 HD-SDI Input Module (optional)
Not available for purchase at Barco for use in Taiwanese market.
Depending on the projector configuration the projector card cage is either equipped with an ICP or
ICMP. In case an ICP is installed then an IMB, IMS, or HDSDI input module can be optionally
inserted into the slot below the ICP. This is not the case if the ICMP is installed. For more
information about the ICMP see chapter called ICMP.
Location of the source input ports
Image 7-4
1
SMPTE 292/424 input, port A (maximum cable length of 30 m allowed)
2
SMPTE 292/424 input, port B (maximum cable length of 30 m allowed)
SMPTE
Society of Motion Picture and Television Engineers - A global organization, based in the United
States, that sets standards for baseband visual communications. This includes film as well as video
standards.
HD-SDI settings
General settings
Port
Port type
A or
HDSDI Single
B
link
3GSDI link
Source: 2K
Mode
Scan type
4:2:2 10
Progressive
bits/color
Progressive - field
bit normal
Progressive - field
bit inverted
Progressive SF -
2nd field dominant
Progressive SF -
1st field dominant
4:2:2 12
Progressive
bits/color
4:4:4 10
Progressive
bits/color
Input & communication
1
2
SMPTE 292/424 IN
A
SEL
SYNC OK
Advanced settings
Color
Pixel mapping
space
YCbCr
HDSDI-Single link
YCbCr
3G-level A-Single
link
3G-level B-Dual
link
RGB
3G-level A-Single
link
R5906897 /02
B
SEL
SYNC OK
Calibration
Single
Single
Prometheus III
85
Advertisement
Table of Contents
