Table of Contents
Advertisement
7. Lenses & lens holder
Image 7-37
5. Gently turn (by hand) the Scheimpflug adjustment nut at the lower left of the Lens Holder (reference 4 image 7-38) against the
Lens Holder front plate without disturbing the projected image.
6. Turn in the set screw at the lower left of the Lens Holder (reference 14 image 7-38) without disturbing the projected image. Use
a 3mm Allen wrench.
Note: Ensure that the edges of the projected test pattern remain in place on the screen. Any movement of the image will affect
the Scheimpflug adjustment.
Tip:
Fasten the set screw and the Scheimpflug nut alternately, without disturbing the projected image, until the Scheimpflug
nut and set screw are completely tightened.
4
Image 7-38
7. Fasten the lock nut at the lower left of the Lens Holder. Use a 10mm nut driver.
78
11
24
14
21
11
R5906753 DPXK BLP SERIES 20/11/2017
Advertisement
Table of Contents
