Table of Contents
Advertisement
9. ICMP
How to install a HDD ?
1. Ensure that the projector is switched off.
2. Prepare the HDD for insertion by moving the latch towards the left and push the unlock button to open the handle.
Image 9-15
3. Insert the HDD into the HDD slot. Ensure that the handle is sufficiently open so that the hook (reference 1) of the handle can
pass the front plate of the ICMP.
Image 9-16
4. Push the HDD completely and firmly inside its slot, close the handle, and move the latch towards the right.
Image 9-17
5. Switch on the projector.
In case you replace one HDD (e.g. degraded mode) the ICMP automatically starts with the RAID recovery
process. The red LED of the HDD which has to be rebuilt is blinking. This process takes about 200 GB per
hour. Once the RAID is completed the red LED turns off.
C
AUTION
to ensure that the content integrity is preserved and that the show is not interrupted.
112
:
It's strongly recommended to complete the RAID recovery process prior to starting a show. This
1
R5906753 DPXK BLP SERIES 20/11/2017
Advertisement
Table of Contents
