Table of Contents
Advertisement
Wall mounting
To install the standalone cooler in wall mounting mode follow this procedure:
1. Place the stand alone frame against the wall (side indicated with 1) and mark the drilling hole. Any hole in the frame can be used
as fixation point but make sure to divide the fixation point over the complete frame.
It can be mounted in portrait mode (A) or in landscape mode (B).
Note: In portrait mode the coolers must be mounted with the cooling tubes up. In landscape mode the cooler must be mounted
with the cooling tubes to the left.
1
Image 6-9
1
Wall side
U
U brackets location
A
Portrait mode
B
Landscape mode
When mounting the cooler assembly, the U brackets which will be mounted on the housing must be fixed to the indicated position
(U) on the frame.
-
For portrait mode the U brackets must be mounted on top (cooling tubes will be facing upwards) .
-
For landscape mode the U brackets are mounted on the left side (cooling tubes will be facing to the left).
Continue with "Installing the brackets on the cooler housing", page 55.
6.5
Installing the brackets on the cooler housing
Necessary parts
•
2 front brackets (U-brackets)
•
2 equal rear brackets
•
4 Hex Screws M5x8
•
4 Hex Screws M5x12
How to install the brackets
1. Fixate the U-bracket (on both sides) to the side of the cooler housing with 2 screws (M5x12).
R5906753 DPXK BLP SERIES 20/11/2017
U
A
6. Physical installation stand alone cooler
1
B
U
55
Advertisement
Table of Contents
