Barco DP2K-36BLP User And Installation Manual page 161

y
C
t
B
t
Image 16-2
Correction of native color gamut towards desired color gamut (electronic correction)
Electronic correction
The electronic correction adapts the native color gamut towards the desired (target) color gamut (e.g. DC28_DCI_Xenon.TCGD).
This correction is introduced by the DMD drivers and is also called 'P7 correction'. The electronic correction takes place once the
MCGD file of the projector is mapped with the TCGD file of the film.
Influence of aspect ratio
The aspect ratio of the projected image could have a small influence upon the measured xy coordinates. Therefore, it's recom-
mended to save the xy coordinates per aspect ratio in separate MCGD files.
C
AUTION
cessfully. See "White point calibration", page 155.
Color gamut calibration procedure
1. Check if the white point calibration is done. If not see "White point calibration", page 155.
2. Setup the ambient light conditions as it should be during the play out of the movie. (e.g. only the stairs and emergency exit
lighting is switched on).
Note: In an optimal setup less than 1% of light from any other source than the light from the projector should illuminate the
screen.
3. Sequentially measure and enter the xy coordinates of the three primary colors (red, green, blue) and full white. Use therefore
the Communicator. Go to Installation > Color calibration > Measure native colors. For detailed instructions see user guide of the
Communicator.
Caution: Ensure that the correct projection mode is selected: 2D or External 3D.
Caution: In case of 3D, measure the xy coordinates once through the left eye glass of the 3D goggles and once through the
right eye glass.
Tip: When using the wizard for white point calibration you can immediately proceed with the electronic correction.
4. Once all xy coordinates are measured and entered proceed by saving all measured values into a MCGD file.
Put in the MCGD file name the type of projection mode (2D or External 3D) and the aspect ratio (FLAT, SCOPE).
Tip:
5. Map the MCGD file with the TCGD file. Use for that the Communicator. Go to Installation > Color calibration > Select target
colors. For detailed instructions see user guide of the Communicator.
6. In addition you can check if the corrected colors comply. Use therefore the Communicator. Go to Installation > Color calibration
> Verify corrected colors. For detailed instructions see user guide of the Communicator.
R5906753 DPXK BLP SERIES 20/11/2017
G
t
Y
t
R
t
M
t
:
Prior to start with color gamut calibration ensure that the white point calibration is finalized suc-
x
16. Color calibration
157