Table of Contents
Advertisement
7. Lenses & lens holder
Image 7-22
2. Fully loosen the Scheimpflug nut at the lower left of the Lens Holder (reference 4 image 7-23). Use a 13mm nut driver.
4
Image 7-23
3. Turn the three Scheimpflug adjustment nuts, reference 1, 2 and 3 image 7-24, until the front of the nut (reference 5 image 7-24)
is equally aligned with the front of the threaded rod (reference 6 image 7-24). Use a 13mm nut driver.
Note: This is the nominal position of the Lens Holder.
Caution:
Do not remove any of the Scheimpflug adjustment nuts completely from the threaded rod. Otherwise the lens holder
front plate with lens will fall off.
1
4
Image 7-24
4. Zoom the lens for maximum image on the screen (WIDE) and focus the center of the projected image using the motorized focus
control (Local Keypad).
72
11
4
2
3
21
11
1
2
R5906753 DPXK BLP SERIES 20/11/2017
3
3 x
3 x
5
6
Advertisement
Table of Contents
