How To Control The Unit; Master/Slave Built In Preprogrammed Function; Easy Controller - ACME LED WAVE 100 User Manual

setup. Back to the functions without any change press MENU button.

4. How To Control The Unit

You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will
be effected at once. Every time you turn the unit on, it will show "CP21" on the display and move
all the motors to their 'home' position. After that the unit will be ready to receive DMX signal or
run the built in programs.

4.1 Master/Slave Built In Preprogrammed Function

The fixture will allow you to link 2 fixtures together and operate without a controller. In
Master/Slave mode, the first fixture whose DMX input jack has with nothing connect need to set
as master and the other unit need to set as slave 1 via menu, then the first unit will control the
other to give an automatic and synchronized light show. This function is good when you want an
instant show. Any fixture can act as a Master or as a Slave.

4.2 Easy Controller

The easy remote control is used only in master/slave mode. By connecting to
the 1/4" microphone jack of the first unit, you will find that the remote
controller on the first unit will control all the other units for Stand by, Function
and Mode selection.
Stand By Blackout the unit
1. Fast Sync. Strobe
Function
2. Medium Sync. Strobe
Show 0 - 2
10B