Table of Contents
Advertisement
will control the others to give an automatic, sound activated, synchronized light show. This
function is good when you want an instant show. Any fixture can act as a Master or as a Slave
16‐light show:
In slave mode, slave 1 means the unit works as master, slave 2 means 2‐light show, slave 3 means
3‐light show and so on, In order to create a great light show, you can set the second unit to slave 2
to get contrast movement to each other, even if you have two units only.
4.2. Easy Controller (by CA‐8)
The easy remote control is used only in master/slave mode. By connecting to the 1/4"
microphone jack of the first unit, you will find that the remote controller on the first
unit will control all the other units in Stand by, and Mode selection.
Blackout
To blackout all the fixture
Strobe
1. Synchronous
Strobe in white color
Function
2. The same
color chase
3. Different
color strobe
Mode
Sound 1
(LED OFF)
4.3 DMX Controller
By using a universal DMX controller to control the units, you will need to set a DMX address from 1
to 512 so that the units can receive the DMX signal.
Press the MENU button to show
will blink. Use the DOWN and UP buttons to change the DMX512 address. Once the address has
been selected, press the ENTER button to store. To return to the main menu without any changes
press the MENU button or wait for one minute.
Colors select
1. Red
2. Blue
Color Chase
3. Purple
1. The same color
4. Orange
2. Different color
5. Green
3. One light chase
6. Yellow
4. Two lights chase
7. Magenta
5. Four lights chase
8. Cyan
9.White
Manual
Sound 2
(LED ON)
(LED slow blinking)
on the display. Press the ENTER button and the display
11A
Color Fade
1. Fast speed
2. Middle speed
3. Slow speed
Auto
(LED fast blinking)
Advertisement
Table of Contents
