Yamaha Sirius T110LSE Service Manual page 80

ADJUSTING THE DRIVE CHAIN SLACK
1
a
b
2
3
1. Stand the vehicle on a level surface.
w
Securely support the vehicle so that there is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated.
2. Spin the rear wheel several times and find
the tightest position of the drive chain.
3. Check:
9drive chain slack a
Out of specification → Adjust.
Drive chain slack
25–35 mm (0.98–1.38 in)
4. Adjust:
9drive chain slack
MMMMMMMMMMMMMMMMMMMMMMMM
a. Loosen the wheel axle nut 1.
b. Loosen both locknuts 2.
c. Turn both adjusting nuts 3 in direction a
or b until the specified drive chain slack is
obtained.
Direction a a
Direction b b
NOTE:
To maintain the proper wheel alignment, adjust
both sides evenly.
d. Tighten both locknuts to specification.
Locknut
7 Nm (0.7 m·kg, 5.0 ft·lb)
e. Tighten the wheel axle nut to specification.
Wheel axle nut
60 Nm (6.0 m·kg, 43 ft·lb)
LLLLLLLLLLLLLLLLLLLLLLLL
3-27
CHK
ADJ
Drive chain is tightened.
Drive chain is loosened.