Yamaha Sirius T110LSE Service Manual page 243

1
a
1
2
1
a
HANDLEBAR
3. Install:
9bushings
9washers
9handlebar
9wire harness strap
Refer to "CABLE ROUTING" in chapter 2.
4. Install:
9handlebar grip
MMMMMMMMMMMMMMMMMMMMMMMM
a. Apply a thin coat of rubber adhesive onto
the left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
w
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
LLLLLLLLLLLLLLLLLLLLLLLL
5. Install:
9left handlebar switch 1
NOTE:
Align the projection a on the left handlebar
switch with the hole in the handlebar.
6. Install:
9throttle grip 1
9throttle cable 2
NOTE:
Lubricate the inside of the throttle grip with a thin
coat of lithium-soap-based grease and install it
onto the handlebar.
7. Install:
9right handlebar switch 1
NOTE:
Align the projection a on the right handlebar
switch with the hole in the handlebar.
w
Make sure the throttle grip operates smooth-
ly.
6-48
CHAS
16 Nm (1.6 m·kg, 12 ft·lb)