Yamaha Sirius T110LSE Service Manual page 115

c
d
CYLINDER HEAD
8. Check:
9"I" mark a
Align the "I" mark on the generator rotor
with the stationary pointer b on the crank-
case.
9"I" mark c
Align the "I" mark on the camshaft sprocket
with the stationary pointer d on the cylinder
head.
Out of alignment → Correct.
Refer to the installation steps above.
9. Measure:
9valve clearance
Out of specification → Adjust.
Refer to
CLEARANCE" in chapter 3.
10. Install:
9camshaft sprocket cover screws
9camshaft sprocket cover
11. Install:
9tappet cover (exhaust side)
9tappet cover (intake side)
12. Install:
9spark plug
13. Install:
9intake manifold bolts
9intake manifold
14. Connect:
9air induction system pipe bolts
9air induction system pipe
4-16
ENG
"ADJUSTING THE
7 Nm (0.7 m•kg, 5.0 ft•lb)
18 Nm (1.8 m•kg, 13 ft•lb)
12.5 Nm (1.25 m•kg, 9.0 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)
23 Nm (2.3 m•kg, 17 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)
VALVE