Factory Defaults; Quick Reference - RayTek GP Series Operating Instructions Manual

GP Monitor

3.4.12 Factory Defaults

If you need to reset the GP monitor to its factory default settings, you
can do so by pressing and holding the
the button 3 times.
Parameter
Emissivity
Sensing Head/Device
type
Display Resolution
Setpoints (SP1, SP2)
Peak hold
Valley hold
Averaging
Ambient Temperature
Compensation (t-amb)
Offset
Table 10: Factory-set Default Values

3.5 Quick Reference

On the following pages are quick reference charts for setting up the
GP Monitor with sensing head and input devices and for adjusting
the monitor's normal and advanced functions.
34
Value Setting Range
0.95 0.1 - 1.09
H001 H001 - H007
0 0 - 4
off According to Sensing
Head/Device type
0-998 s (999 s = ∞)
0
0-998 s (999 s = ∞)
0
0 – 60 s
0
0 -18 to 1200°C
(0 to 2200°F)
0 -50 to 50°C
(-99 to 99°F)
Rev. F 10/2011
button and then pressing
Remarks
For 0 - 5 V, 4 - 20 mA and
thermocouple inputs,
emissivity is not functional
see section 3.4.4, page
23
∞: reset by hardware
∞: reset by hardware
GP Series