Download Print this page

Thermocouple Output - RayTek GP Series Operating Instructions Manual

Hide thumbs Also See for GP Series:

Table of Contents

GP Monitor

1. Press the

button and the

The Peak Hold display appears, see Figure 20.

2. Press the

displays:

3. To adjust the display and output offset, press the

more.

4. Set the display by using the

5. Press the

button until the temperature mode displays.

3.4.10 Thermocouple Output

Thermocouple output is factory preset as inactive. To adjust and set

the type of thermocouple output, complete the following steps:

1. Press and hold the

them both. The Peak Hold display appears, see Figure 20.

2. Press the

indicator displays as shown in the following figure:

button several times until the Offset indicator

Figure 24: Offset Indicator Display

button, and press the

button several times until the thermocouple output

Figure 25: Thermocouple Output

Rev. F 10/2011

button simultaneously then release.

and

buttons.

button, then release

button once

GP Series

Table of Contents

Do you have a question about the GP Series and is the answer not in the manual?