Table of Contents
Advertisement
Thermocouple output is available for H004 and H005 only
if either °C or °F is activated!
3.4.7 Signal Processing
The Peak Hold,Valley Hold, and Average times are factory set at 0
seconds and are not activated. If you don't need to use these signal
processing functions, no adjustments are necessary.
Only one signal processing setting can be active at a time!
To set and activate, complete the following steps:
1. Press and hold the
them both. The Peak Hold display appears:
2. Press the
Hold value in seconds.
3. Set the display by using the
turns off Peak Hold.
4. Press the
button again and the Valley Hold display appears.
GP Series
button and press the
Figure 20: Peak Hold Display
button again and the display shows the current Peak
and
buttons. Note that "000"
Rev. F 10/2011
GP Monitor
button and release
29
Advertisement
Table of Contents
Need help?
Do you have a question about the GP Series and is the answer not in the manual?