Interface Parameters - Proxim ORiNOCO AP-700 User Giude

Command Line Interface (CLI)
Parameter Tables

Interface Parameters

Wireless Interface Parameters
The wireless interface group parameter is wif. The wireless interface uses table index 3.
Common Parameters to 802.11a, and 802.11/b/g
Name
Wireless Interfaces
Table Index
Operational Mode
Network Name
Auto Channel Select
(ACS)*
DTIM Period
RTS/CTS Medium
Reservation
MAC Address
Closed System
Wireless Service Status
Supported Frequency
Channels
Load Balancing Max
Clients
Distance Between APs
Antenna Diversity
Transmit Power Control
Transmit Power Control
Back-Off
* For 802.11a APs certified in the ETSI and TELEC regulatory domains and operating in the middle frequency band, disabling Auto Channel
Select will limit the available channels to those in the lower frequency band.
†
Wireless Service Status cannot be shut down on an interface where Rogue Scan is enabled.
‡
Distance Between APs allows the AP to perform better in high noise environments by increasing the receive sensitivity and transmit defer
threshold, as follows:
Type
Group N/A
Integer 3
Integer 1 = dot11b-only
2 = dot11g-only
3 = dot11bg
4 = dot11a
5 = dot11g-wifi
DisplayString 1 - 32 characters
My Wireless Network (default)
Integer enable (default)
disable
Integer 1 - 255
1 = default
Integer 0 - 2347
Default is 2347 (off)
PhyAddress 12 hex digits
Integer enable
disable (default)
†
Integer 1 = resume
2 = shutdown
Octet String Depends on Regulatory
Domain
Integer 1 - 63
‡
Integer 1 (large) (default)
2 (medium)
3 (small),
4 (minicell)
5 (microcell)
Integer 1 (Antenna 1),
2 (Antenna 2),
5 (Auto; both antennas)
(See
Diversity)
Integer enable
disable
Integer 0 - 35 (dBm)
Value
Configure Antenna
AP-700 User Guide
Access CLI Parameter
R wif
R index
RW mode
RW netname
RW autochannel
RW dtimperiod
RW medres
R macaddr
RW closedsys
RW wssstatus
R suppchannels
RW lbmaxclients
RW distaps
RW atdiversity
RW txpowercontrol
RW currentbackofftpcvalue
182