Always On Jumper Setting (J36) - Kontron KTQM87/mITX User Manual

KTD-N0886-E

Always On Jumper setting (J36)

7.13
If the Jumper is installed in the (J36) Always On position, the board will automatically power up, when the
external power supply is switched ON. This action is independent of the settings in the BIOS setup.
However, if the Jumper is in the (J36) Default position or is not mounted, the settings in the BIOS setup
controls if the board automatically powers up.
For more information regarding the (J36) Always ON settings, refer to the following table.
Jumper in Default position (pin 2&3)
J36
Pin 1-2 Pin 2-3 State SO State S5
X
X
X
X
- -
- -
Page 41
J36 pin1
State After G3 Always
ON
X Enabled Board powers on automatically, when the
X Enabled Board powers on automatically, when the
X Enabled Board powers on automatically, when the
X Disabled Activate the power on button (PWRBIN_IN#) to
X Enabled Board powers on automatically, when the
X Disabled Activate the power on button (PWRBIN_IN#) to
KTQM87/mITX Users Guide
Comment
external power supply is switched ON.
external power supply is switched ON.
external power supply is switched ON.
switch on the board.
external power supply is switched ON.
switch on the board.
Internal Connectors